Your present location:HomeSupportSupport info > The design of HPGR carbide stud

The design of HPGR carbide stud

Writer:Zigong TianyiSource:Zigong Tianyi Number of visits: Date:Apr 16,2018

The design of HPGR carbide stud

 

Based on years of experience and analysis of the damaged form of HPGR carbide stud, the influence of stress distribution rules, the effectiveness of crushing mechanism, etc, we analyze the structure of HPGR carbide stud. The preliminary discussion is as follows:

1.The structure of HPGR carbide stud:

2.Analysis of structural use

(1)If material is high hardness and low viscosity, the surface of the HPGR will not be easy to form the material-wear-resisting layer. Under the continuous pressure of high pressure roller, carbide stud force is larger. So we should choice type B carbide stud to Improved service life.

 

(2)If material is low hardness and high viscosity, the surface of the HPGR will be easy to form the material-wear-resisting layer and the stress of carbide stud is small. So we should choice type A.

 

(3)If the diameter of HPGR and the daily processing capacity is large, and the load change is big and unstable, we should choice the type C to reduced production cost.

 

Previous post:

Next post:HPGR studed roller

TypeInfo: Support info

Keywords for the information:design of hpgr stud  hpgr carbide stud  carbide stud  type of hpgr stud